Four common faults when manufacturers overhaul CNC lathes

The information value displayed on the control panel is inconsistent with the actual cutting value of the CNC machine tool manufacturer: This common fault is mostly related to part inspection components and is caused by the loss of a single pulse during rapid cutting.

After the system starts, the system gets stuck: usually because the CNC machine tool manufacturer's statistical data is confusing or inadvertent factors cause the system to enter an infinite loop. The CNC machine tool manufacturer must restart after standby during overhaul; if troubleshooting cannot be performed, all operating memories must be cleared and the main parameters of the CNC machine tool must be re-entered.

Continuous operation of the lathe tool holder or the required tool position cannot be accurately positioned: the reason will be a short circuit in the transmission plate wire connector or power plug, or a short circuit in the Hall element. Repair or replace the relevant components

LatheThe tool holder suddenly stops running, and the motor vibrates and does not run: manually rotate the handle. If a part is too heavy or stuck, it is a mechanical equipment problem, such as there is dirt in the steel ball steel wire dovetail guide: if the full-length part is relatively light, it is determined to be drilled too deeply or cut too fast.

Alarm solution: Generally, when there is an error alarm number on the display, you can check the "Error Code Table" in the maintenance manual to find out the causes of common faults and take effective countermeasures.